Standard ASME Hot Water Storage Tanks Cement Lined Hot Water Storage Tanks Prices With Optional R16 Foam Insulation

MOST OF OUR TANKS CAN ALSO BE
BUILT IN STAINLESS STEEL USING IN-STOCK MATERIAL – PLEASE INQUIRE

  • Vertical 160# ASME (HLW) for potable hot water.

  • Finished in shop primer.

  • Outside diameter from 36 inches to 72 inches.

  • Angle leg support.

  • 11″ x 15″ (28 x 38 cm) handhole.

  • Maximum Temperature: 210oF, 99oC.

  • 2-1/2″, 3″ FNPT connections (see drawings).

  • ADD ONE WEEK FOR OPTIONAL FOAM INSULATION.

  • Cement lining adds 5 lbs/ft2 to the shipping weight.

STANDARD HOT WATER TANKS
TECHNICAL SPECIFICATIONS

  • These Hanson lined potable hot water storage tanks are built and tested in accordance with the A.S.M.E. Boiler and Pressure Vessel Code Section IV for potable hot water
    storage tanks and bear the “HLW” stamp, and serial number, national board number as required.

  • A copy of the A.S.M.E. data sheet HLW-6, signed by an A.S.M.E. authorized inspector, will be sent with the invoice if requested at time of order.

  • Standard exterior paint system is power buff to SSPC-SP3 plus one coat 2/3 MIL DFT rust resistant primer. Standard interior finishes are porcelain enamel, aka “GLASS”,
    epoxy or cement.

  • All tappings and flange openings are plugged and covered before shipment. Manway covers are installed for shipping only, and must be adjusted and tightened before the
    tank is pressurized.

  • Sacrificial magnesium alloy anodes are shipped loose with all glass lined tanks for installation at the jobsite. These must be checked periodically in service and
    replaced if necessary to protect the tank lining.

  • The A.S.M.E. name plate and the supplied lift lugs are installed to allow clearance for tank insulation, which is available at extra cost.

  • Water storage tanks are guaranteed free from defects in material and workmanship for one year from the date of shipment, FOB our factory. Full limited warranty terms
    are available on request.

Material Pricing Subject To Change Based On Market Volatility
Resulting From Implementation Of Section 232 Tariffs And Availability

Notes:

  • All prices are FOB our plant, Los Angeles, California.
  • In stock tanks cannot be modified.
  • Standard styles can be modified at nominal cost. The part# will change.
  • DRAWINGS ARE UPDATED TO CURRENT A.S.M.E. DATE FOR NEW ORDERS.
  • If the capacity or working pressure you need is not listed, contact us for a prompt quotation.
  • TANKS SHIPPED BY TRUCK MUST BE SKIDDED FOR SHIPMENT - CALL FOR PRICING.
  • As well as ASME, we can meet other domestic and international codes. EG: ABS, USCG, Canadian, Lloyds and DNV.
  • Rev. 080520182135

PRICES